AquaLink RS
All Button
Simulator Instructions
To Operate the AquaLink
RS Control Panel
Open the Alwin folder
and from it open the Pwrcntr (Power Center)
file. The Pwrcntr
file is a simulation of the AquaLink RS Power Center Bezel and
therefore must
be open so the Controller can communicate.
Next open the
AquaLink folder and from it open the file named Print (Control Panel). You can now program and operate the
equipment. To open the OneTouch double click on Smallcp.
Note:
Setup allows you to change the Controller color
scheme, Delay Override allows you to cancel the safety delay in effect.
To change the model
of AquaLink RS return to Power
Center -
Untitled and
click on Model. The model menu will open. Click on the part number
(these are
part numbers for the PPDs) to high-light. When you return to the
AquaLink
control panel the buttons, and operation will change to the model you
chose.
If
you change the
model to an RS 12, 16, 2/10 or 2/14 an auxiliary Power Center
should also be opened. In the Alwin folder double click on Remaux (Remote Power Center).
To change how fast
the simulator’s clock runs, for testing programs, you can click on Time
Scaling
at the Power
Center -
Untitled, the Set Time Scale
Factor menu will open. Normal time is a Scale Factor of 1, changing the
scale
from 1 to 60 would increase the simulator Controller clock speed so 60
minutes
of simulated time would pass in one minute of real time.
Note: it
is very difficult to program equipment when the
clock is running fast, return setting to 1 after testing.
Opening the file
labeled Simio in the Alwin folder and you can change temperatures, set
Dip
Switches, operate the Spa Side Switch and change the battery voltage.
Opening the TeleLink
and/or
the 8button from the Alwin folder will allow you to simulate phone
communication and the SpaLink (8 Button Remote) operation.
